1ST / Reverse Brake and One-Way No. 2 Clutch Inspection
1st / Reverse Brake and One-Way No. 2 Clutch InspectionReference: 1st / Reverse Brake and One-Way No. 2 Clutch Disassembly and Reassembly
1. Check that sliding surfaces of friction, separator and retaining plates are not worn or burnt. If necessary, replace with a new one.
NOTE:
^ If friction plate lining is exfoliated, discolored or worn hardly, replace all friction plates.
^ Before assembling new friction plates, soak them in A/T fluid for at least two hours.
2. Measure height of several 1st / reverse brake piston return spring including plate.
1st / reverse brake piston return spring height
Standard: 19.55 mm (0.77 inch)
NOTE: Do not apply excessive force when measuring spring height or it is not measured accurately.
