P1393

DTC P1393: Rough Road Sensor Circuit High Voltage

Wiring Diagram:

Circuit Description
The Rough Road (G) sensor is a vertical low g-acceleration sensor. By sensing vertical acceleration caused by bumps or potholes in the road, the Engine Control Module (ECM) can determine if the changes in crankshaft speed are due to engine misfire or are driveline induced. If the G sensor detects a rough road condition, the ECM misfire detection diagnostic will be deactivated. The G sensor at rest output should be between 2.35 - 2.65 V (+1G). During a rough road condition, the voltage output can vary between 0.5 (-1G) and 4.5 V (+3G).

Conditions for Setting the DTC
- G sensor output indicates above 4.9 V.
- Engine is running more than or equal to 10 seconds.

Action Taken When the DTC Sets
- The Malfunction Indicator Lamp (MIL) will not illuminate.
- The ECM will record operating conditions at the time the diagnostic fails. This information will be stored in the Freeze Frame and Failure Records buffers.
- A history DTC is stored.

Conditions for Clearing the MIL/DTC
- A history Diagnostic Trouble Code (DTC) will clear after 40 consecutive warm up cycles without a fault.
- The DTC(s) can be cleared by using the scan tool.
- Disconnecting the ECM battery feed for more than 10 seconds.

Diagnostic Aids
Check for the following conditions:
- Poor connection at the ECM - Inspect the harness connections for backed-out terminals, improper mating, broken locks, improperly formed or damaged terminals and poor terminal-to-wire connection.
- Damaged harness - Inspect the wiring harness for damage. If the harness appears to be OK, observe the G sensor display on the scan tool while moving connectors and wiring harnesses related to the sensor. A change in the display will indicate the location of the fault.

Since the G sensor shares the ECM 5 volt reference and ground terminals with the A/C Pressure Sensor, a damaged A/C Pressure Sensor harness or sensor could cause a G sensor DTC to set.

Refer to Multiple ECM Information Sensor DTCs Set.

The G sensor will give correct voltages only if it is level and mounted securely to its bracket. Reviewing the Failure Records vehicle mileage since the diagnostic test last failed may help determine how often the condition that caused the DTC to be set occurs. This may assist in diagnosing the condition.

Test Description
Number(s) below refer to the step number(s) on the Diagnostic Table.
1. The On-Board Diagnostic (OBD II) System Check prompts the technician to complete some basic checks and store the Freeze Frame and Failure Records data on the scan tool if applicable. This creates an electronic copy of the data taken when the malfunction occurred.
The information is then stored on the scan tool for later reference.

Step 1-9:

Step 10-13:

Troubleshooting