P2119

DTC P2119: Throttle Closed Position Performance

Wiring Diagram:

Circuit Description
The Engine Control Module (ECM) controls the throttle valve by applying a varying voltage to the control circuits of the Throttle Actuator Control (TAC) motor. The ECM monitors the duty cycle that is required to actuate the throttle valve. The ECM monitors the Throttle Position (TP) sensors 1 and 2 to determine the actual throttle valve position.

Conditions for Setting the DTC
Ignition ON.

Action Taken When the DTC Sets
- The Malfunction Indicator Lamp (MIL) will not illuminate.
- The ECM will record operating conditions at the time the diagnostic fail. This information will be stored in the Freeze Frame and Failure Records buffers.
- A history DTC is stored.

Conditions for Clearing the MIL/DTC
- A history DTC will clear after 40 consecutive warm up cycles without a fault.
- The DTC(s) can be cleared by using the scan tool.

Diagnostic Aids
- Inspect for a condition in which the throttle valve may have been held open. For example, ice may have formed in the throttle bore causing the throttle valve not to close.
Observe the Freeze Frame/Failure Records.
- The throttle valve is spring loaded to a slightly open position.
- The throttle valve should not be completely closed or open any more than a specified amount.
- The throttle valve should move open and to the closed position without binding under the normal spring pressure.
- The throttle should NOT be free to move open or closed WITHOUT spring pressure.
- For an intermittent, refer to Intermittents Intermittents.

Test Description
Number(s) below refer to the step number(s) on the Diagnostic Table.
1. This step determines if the condition exists. A TP sensor DTC may cause this DTC to set.
2. When the ignition is turned ON, the ECM operates the throttle actuator control motor to verify the integrity of the system prior to start-up. This can be seen by the momentary flash of the test lamp as the ignition is turned ON.

Step 1-8:

Step 9-19:

Troubleshooting