Steering Wheel With SIR Removal and Installation

Steering Wheel with SIR Removal and Installation

Tools Required: KM-210-A Steering Wheel Puller

Removal
1. Disconnect the negative battery cable.
2. Remove the SIR module.





3. Remove the steering wheel nut and the retaining clip.
4. Remove the steering wheel using the steering wheel puller KM-210-A.





5. Unclip the contact ring from the steering wheel, if necessary.

Installation
1. Clip the contact ring on the steering wheel, if necessary.
2. Align the match marks on the steering wheel and the steering column shaft. Turn the signal canceling cam on the wheel to the left.
3. Install the retaining clip and the steering wheel nut.
^ Tighten the steering wheel nut to 38 Nm (28 ft. lbs.).
4. Bend the tabs to secure the retaining clip.
5. Install the SIR Module.





6. Connect the negative battery cable.