B1650
DTC B1650: Crash Recorded in 1st Stage Frontal AirbagCircuit Description
When the ignition switch is turned to ON, the Sensing and Diagnostic Module (SDM) will perform turn-ON test to diagnose critical malfunctions within SDM itself.
In case of 1st stage airbag inflation by a vehicle collision, the SDM maintains warning lamp ON and then all the airbag system including SDM, Airbag Module and wiring should be replaced.
DTC B1650 Will Set When
The history of 1st stage airbag inflation or belt pretensioner explosion is in the SDM.
Troubleshooting
WARNING:
^ The Sensing and Diagnostic Module (SDM) can maintain sufficient voltage to deploy the airbags and pretensioners for 1 minute after the ignition is OFF and the fuse has been removed. If the airbags and pretensioners are not disconnected, do not begin service until 1 minute has passed after disconnecting power to SDM. Otherwise, injury could result.
^ During service procedure, be very careful when handling the SDM. Never strike or jar the SDM. Never power the Supplemental Inflatable Restraints (SIR) when the SDM is not rigidly attached to the vehicle. All SDM mounting bolts must be carefully tightened, and the arrow on the SDM must be point toward the front of the vehicle to ensure proper operation of the SIR. The SDM could be activated if it is powered when it is not rigidly attached to the vehicle, resulting in unexpected deployment and possible injury.