Cylinder Block Heater Removal and Installation (If Equipped)

Cylinder Block Heater Removal and Installation (If Equipped)

Removal
1. Disconnect negative (-) cable at battery.
2. Drain engine coolant.
3. Remove exhaust manifold cover.
4. Remove engine block heater (1).








Installation

Reverse removal procedure for installation, noting the following.
^ Install cylinder block heater (1) in the direction as shown in figure.





^ Tighten cylinder block heater mounting bolt (1) to specified torque.

Tightening torque
Cylinder block heater mounting bolt a: 11 Nm (1.1 kgf-m, 8.0 ft. lbs.)





^ Refill coolant.
^ Finally, start engine and check for engine coolant leaks and exhaust gas leakage.