Liftgate Window Glass: Service and Repair
REAR END DOOR GLASS REMOVAL AND INSTALLATIONReference: Rear End Door Window Components
Refer to Windshield Removal and Installation as preparation, removal and installation procedures are basically the same. However, note the following.
^ Observe the following precautions when applying adhesive (1) along glass (2) edge.
^ Adhesive (1) should be applied evenly especially in height.
^ Be careful not to damage primer (3).
^ Install glass (2) on rear end door panel (5) noting the following.
^ With the position of fastener (4) properly aligned.
^ With the position of ceramic mark (6) aligned to the mark (7) of rear end door panel (5).
^ Press glass against body quickly after adhesive (1) is applied.
Adhesive amount specifications and position for rear end door glass
^ Height "a": 13 mm (0.51 in.)
^ Width "b": 7 mm (0.28 in.)
^ Width "c": 14 mm (0.55 in.)
^ Position "d": 15 mm (0.59 in.)
^ Position "e": 42 mm (1.65 in.)
^ Position "f": 37 mm (1.46 in.)
^ Position "g": 9 mm (0.35 in.)
^ Position "h": 14 mm (0.55 in.)
