Clutch Pedal Position Sensor / Switch: Testing and Inspection

Clutch Pedal Position (CPP) Switch Inspection and Adjustment

Inspection
Check for resistance between terminals under each condition below. If check result is not satisfactory, replace.
CPP switch resistance
When switch shaft is pushed (1): Continuity
When switch shaft is free (2): No continuity





Adjustment
With clutch pedal (1) depressed, adjust switch (2) position so that clearance between end of thread and clutch pedal arm is within specification and then tighten lock nut to specified torque.
Clearance between end of thread and clutch pedal arm "a": 1.5 - 2.0 mm (0.06 - 0.08 in.)
Tightening torque
CPP switch lock nut a: 7.5 Nm (0.75 kgf-m, 5.5 ft. lbs.)