DTC Clearance
DTC ClearanceUsing SUZUKI Scan tool
1. Turn ignition switch to OFF position.
2. Connect SUZUKI scan tool to data link connector (DLC) (1) located on underside of instrument panel at driver's seat side.
Special Tool
(A): SUZUKI scan tool
3. Turn ignition switch to ON position.
4. Erase DTC according to instructions displayed on SUZUKI scan tool.
NOTE: To know how to use SUZUKI scan tool, refer to operator's manual for SUZUKI scan tool.
5. After completing the clearance, perform "DTC Check" and confirm if normal DTC (No code) is displayed. DTC Check
6. Turn ignition switch to OFF position, and then disconnect SUZUKI scan tool from DLC.
Not Using SUZUKI Scan Tool
1. Display history DTC by HVAC control module referring to "Not Using SUZUKI Scan Tool" under �DTC Check".
2. Press air intake selector (1) and "A/C" switch (2) at the same time for 5 seconds or more.
3. After completing above Steps, turn ignition switch to OFF position.
4. Perform "DTC Check" and confirm if normal DTC is indicated. DTC Check