Initial Inspection and Diagnostic Overview
Yaw Rate / G Sensor Assembly On-Vehicle InspectionLateral G Inspection
1. Park and level the vehicle with parking brake and fix wheels with chokes.
2. Check yaw rate / G sensor assembly installation condition.
3. Connect SUZUKI scan tool to data link connector (DLC) (1) with ignition switch OFF.
Special Tool (A): SUZUKI scan tool
4. Turn ignition switch to ON position and select menu "DATA LIST" mode of SUZUKI scan tool.
5. Check "G Sensor (lateral)" under "DATA LIST" of SUZUKI scan tool in the following vehicle conditions.
^ Level condition
^ Right-up condition
^ Left-up condition
If Lateral G condition is out of specification, replace yaw rate G sensor assembly.
Lateral G specification
Yaw Rate Inspection
1. Check yaw rate / G sensor assembly installation condition.
2. Connect SUZUKI scan tool to data link connector (DLC) (1) with ignition switch OFF.
Special Tool (A): SUZUKI scan tool
3. Turn ignition switch to ON position and select menu "DATA LIST" mode of SUZUKI scan tool.
4. Check "Yaw rate sensor" under "DATA LIST" of SUZUKI scan tool in the following vehicle conditions.
^ Parking condition
^ Drive vehicle in right turning condition with steering wheel fully turned
^ Drive vehicle in left turning condition with steering wheel fully turned
If yaw rate condition is out of specification, replace yaw rate / G sensor assembly.
Yaw rate specification
NOTE:
^ Drive the vehicle on level ground and at 10 km/h (6.2 mph).
^ Minimum turning radius is 5.3 m (17.4 ft).
