Transaxle Rear Cover Disassembly and Reassembly
Transaxle Rear Cover Disassembly and ReassemblyDisassembly
1. Remove oil seal rings (1).
2. Remove forward clutch accumulator (1), forward clutch accumulator spring (2) and forward clutch accumulator piston (3) cover, by removing 2 bolts.
3. Remove O-ring (4) from forward clutch accumulator piston.
Reassembly
1. Apply A/T fluid to new O-ring and install O-ring (1) to forward clutch accumulator piston (2).
2. Press forward clutch accumulator piston (2) into transaxle rear cover.
NOTE: Do not twist or deviate O-rings during installation.
3. Install forward clutch accumulator spring (3) and forward clutch accumulator cover (4) with 2 bolts.
Tightening torque
Forward clutch accumulator bolts a: 10 Nm (1.0 kgf-m, 7.5 ft. lbs.)
4. Apply A/T fluid to new oil seal rings and install oil seal rings (1) to transaxle rear cover (2).
NOTE:
^ Do not spread oil seal ring ends excessively.
^ Make sure that opening ends of oil seal rings are not lined up so as to prevent fluid leakage.
