Removal and Replacement
Propeller Shaft Assembly Removal and InstallationRemoval
1. Hoist vehicle.
2. Before removing propeller shaft assembly, give match marks (2) on joint flange and propeller shaft as shown.
3. Separate propeller shaft assembly (1) from transfer output flange and rear differential flange.
4. Remove propeller shaft by removing center support nuts (1).
CAUTION: Use care not to drop it. Otherwise, vibration may occur during driving.
Installation
Reverse removal procedure to install propeller shaft, noting the following point.
^ When installing propeller shaft, align the match marks (2). Otherwise, vibration may occur during driving.
^ Use the following specification to torque each bolt and nut.
Tightening torque
Propeller shaft bolt: 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
Center support nut: 55 Nm (5.5 kgf-m, 40.0 ft. lbs.)