Headliner: Service and Repair

HEAD LINING REMOVAL AND INSTALLATION

WARNING: Refer to Air Bag Warning before starting service work.

Removal
1. Remove sun visor (1).





2. Remove dome lights of front (1) and center (2).





3. For hatchback model, remove front pillar upper trims (1) rear side sill scuffs (2), center pillar inner lower trims (3), center pillar inner upper trims (4), back panel trim (5), rear quarter lower trims (6) and rear quarter upper trims (7).





4. For sedan model, remove front pillar upper trims (1), center pillar inner lower trims (3), rear side sill scuffs (2), center pillar upper trims (4), side backs (separate seat model) (6), seat cushion (bench seat model), seat back (bench seat model) and rear pillar inner trims (5).





5. Remove assistant grip (1).
6. Remove head lining clips (2) at rear end and remove head lining (3).





Installation
Reverse removal procedure noting the following.
^ Fix sun visor clip (1) first and adjust head lining in position and fix three clips (2) at rear end.
^ Tighten sun visor screw to specified torque.

Tightening torque
Sun visor screw (a): 4 Nm (0.4 kgf-m, 3.0 ft. lbs.)





^ Tighten rear seat bolt referring to Rear Seat Components.