Ignition Switch: Service and Repair
IGNITION SWITCH REMOVAL AND INSTALLATIONRemoval
1. Disconnect negative cable at battery.
2. Confirm that ignition key is removed.
3. Remove dash side trim (4) and steering column hole cover (1).
4. Turn steering wheel to remove steering column cover screws (3) and then remove steering column covers (2).
5. Remove steering column mounting nuts referring to Step 7) under"Removal" of Steering Column Removal and Installation.
6. Disconnect couplers (1) from ignition switch (2).
7. Remove ignition switch (2) from key cylinder (3).
Installation
Reference: Ignition Switch Inspection
Reverse removal procedure noting the following.
Tighten steering column mounting nuts referring to Step 2) under "Installation" of Steering Column Removal and Installation.