Rear Wiper Removal and Installation
REAR WIPER REMOVAL AND INSTALLATIONRemoval
1. Disconnect negative (-) cable at battery.
2. Remove arm cover (1), rear wiper arm nut (2), rear wiper arm with blade assembly (3), rear wiper pivot cap (4), rear wiper nut (5) and rear wiper seal (6).
3. Remove rear end door trim referring to Rear End Door Lock Assembly Removal and Installation.
4. Disconnect coupler from rear wiper motor.
5. Remove rear wiper motor.
Installation
1. Install rear wiper motor (1) and tighten rear wiper motor mounting bolts to specified torque.
Tightening torque
Rear wiper motor mounting bolt a: 8 Nm (0.8 kgf-m, 6.0 ft. lbs.)
2. Connect coupler to rear wiper motor
3. Install rear end door trim referring to Rear End Door Lock Assembly Removal and Installation.
4. Install rear wiper seal (1), and tighten rear wiper nut to specified torque.
Tightening torque
Rear wiper nut a: 5 Nm (0.5 kgf-m, 4.0 ft. lbs.)
5. Install rear wiper pivot cap (2).
6. Install rear wiper arm with blade assembly (1) to specified position as shown in figure.
7. Tighten rear wiper arm nut to specified torque, and then install arm cover (1).
Tightening torque
Rear wiper arm nut a: 8 Nm (0.8 kgf-m, 6.0 ft. lbs.)
8. Connect negative (-) cable to battery.