Programming and Relearning

Sensor Calibration

CAUTION: If any DTC(s) other than C1075 are detected, sensor calibration can not be completed. Repair the detected DTC first.

NOTE: Steering angle sensor calibration is needed when battery, dome fuse or the steering angle sensor is removed. This sensor calibration can be done with/without SUZUKI Scan Tool.

Using SUZUKI Scan Tool
1. Set steering wheel in straight-ahead position.
2. Connect SUZUKI scan tool to data link connector (DLC) (1) with ignition switch OFF.
Special Tool (A): SUZUKI scan tool





3. Turn ignition switch to ON position and confirm that only any of DTC(s) C1075 is detected. If any other DTC are detected, repair the detected DTC.
4. Park and level the vehicle with parking brake, stop engine with ignition switch ON, set steering in straight and without stepping on the brake pedal.

CAUTION: Hold the above condition in Step 4) to calibrate sensor correctly until sensor calibration is completed.

5. Select menu "SENSOR CALIBRATION" under "MISC. TEST" mode of SUZUKI scan tool and calibrate sensor.
6. After completing the calibration, turn ignition switch to OFF position and disconnect SUZUKI scan tool from DLC.

Not Using SUZUKI Scan Tool
1. Set steering wheel in straight-ahead position.
2. Connect battery terminals and/or fuse and start engine.

CAUTION: When power is not supplied to the steering angle sensor by removing battery or fuse, DTC C1075 is detected and SLIP indicator light (1) flashes. If DTC other than C1075 is detected, SLIP indicator light flushes and other indicator illuminate. In that case, repair the detected DTC first.





3. Drive straight for approximately 35 km/h (21.8 mph) or more and 10 seconds or more.