Front Suspension Frame, Stabilizer Bar and/or Bushing Removal and Installation

Front Suspension Frame, Stabilizer Bar and/or Bushing Removal and Installation (4WD Model)

WARNING: When supporting and installing front suspension frame, be sure to apply some supporting equipment (such as mission jack) at well-balanced position in the center section of front suspension frame so as to prevent from its drop. Otherwise drop and injure.

CAUTION: When removal and installing suspension control arm, be careful not to damage dust boots of suspension control arm joint by drive shaft dust cover and brake dust cover.

Removal
1. Remove front suspension frame, steering gear case assembly and transfer all together.
2. Remove steering gear case assembly from front suspension frame.
3. Remove stabilizer bar (1) with bushing from front suspension frame (2).





Installation

Install front suspension frame by reversing removal procedure, noting the following instruction.
^ Tighten all fosters to specified torque.