P0016

DTC P0016

DTC Detecting Condition and Trouble Area






Wiring Diagram










DTC Confirmation Procedure

NOTE:

If DTCs other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.

1) Run engine at idle speed for 1 min.

DTC Troubleshooting



1.
Was "Engine and Emission Control System Check" performed?
YES
Go to Step 2.
NO
Go to Engine and Emission Control System Check.

2. CKP sensor circuit check

Check CKP sensor circuit according to Step 3 through 4 of P0335 DTC P0335.

Are they in good condition?
YES
Go to Step 3.
NO
Repair or replace defective wire harness.

3. CMP sensor circuit check

Check CMP sensor circuit according to Step 3 through 4 of P0340 DTC P0340.

Are they in good condition?
YES
Go to Step 4.
NO
Repair or replace defective wire harness.

4. CKP sensor and sensor plate check

Check CKP sensor and sensor plate.
- CKP sensor: Crankshaft Position (CKP) Sensor Inspection
- Sensor plate: Sensor Plate Inspection

Are they in good condition?
YES
Go to Step 5.
NO
Repair or replace defective parts.

5. CMP sensor and signal rotor check

Check CMP sensor and signal rotor. Camshaft Position (CMP) Sensor Inspection

Are they in good condition?
YES
Go to Step 6.
NO
Repair or replace defective parts.

6. Valve timing check

Check valve timing. Timing Chain and Chain Tensioner Removal and Installation

Is it in good condition?
YES
Substitute a known-good ECM and recheck.
NO
Adjust valve timing.