Ignition Switch Lock Cylinder: Service and Repair

Ignition Switch Cylinder Assembly Removal and Installation (Non-Keyless Start Model)

Removal

1) Disconnect negative (-) cable at battery.
2) Disable air bag system referring to Disabling Air Bag System Disabling Air Bag System:Except Advanced Air Bag or Disabling Air Bag System Disabling Air Bag System:Advanced Air Bag.
3) Remove steering column upper and lower covers.
4) For immobilizer model, remove immobilizer control module referring to Service and Repair ICM Removal and Installation.
5) Remove ignition switch cylinder assembly as follows.
a) Turn ignition key to "ACC" position.
b) Insert 2 mm (0.078 in.) rod (2) through hole (3) and push ignition switch cylinder lock.
c) Detach ignition switch cylinder assembly (1) from steering lock assembly (4).






Installation

1) Install ignition switch cylinder assembly as follows.
a) Turn ignition key to "ACC" position.
b) In this state, push ignition switch cylinder assembly into steering lock assembly till it clicks.
2) For immobilizer model, install immobilizer control module referring to Service and Repair ICM Removal and Installation.
3) Install upper and lower cover and screws.
4) Connect negative (-) cable at battery.
5) Enabling air bag system referring to Enabling Air Bag System Enabling Air Bag System:Except Advanced Air Bag or Enabling Air Bag System Enabling Air Bag System:Advanced Air Bag.
6) For immobilizer model, if ignition switch cylinder assembly (that is ignition key) has replaced, register ignition key transponder code to ECM referring to Registration of the Ignition Key Registration of the Ignition Key.