C1116

DTC C1116: Steering Torque Sensor Power Supply Circuit

Wiring Diagram










DTC Detecting Condition and Trouble Area






DTC Troubleshooting



1.
Was "EPS System Check" performed?
YES
Go to Step 2.
NO
Go to EPS System Check:Electric Type.

2. DTC check

Is DTC C1153 indicated, together?
YES
Go to applicable DTC troubleshooting.
NO
Go to Step 3.

3. Torque sensor power supply voltage check

With ignition switch turned OFF, disconnect torque sensor connector.
Check for voltage between "E31-3" ("GRN" wire) terminal and body ground with ignition switch ON.

Is it approx. 9 V?
YES
Go to Step 4.
NO
Go to Step 5.

4. Torque sensor power supply voltage check

With ignition switch turned OFF, connect torque sensor connector.
Check for voltage between "E11-8" ("GRN" wire) terminal and body ground with ignition switch ON.

Is it approx. 9 V?
YES
Substitute a known-good P/S control module and recheck.
NO
Replace steering gear case.

5. Torque sensor power supply circuit check

Check that torque sensor power supply circuit is as follows.
- Insulation resistance of wire harness is infinity between "Torque sensor power supply circuit" terminal and each other terminal at torque sensor connector.
- Wiring harness resistance of "Torque sensor power supply circuit" is less than 1 ohms.
- Insulation between "Torque sensor power supply circuit" and vehicle body ground is infinity.

Is circuit in good condition?
YES
Replace P/S control module.
NO
Repair or replace defective circuit.