Manual Transaxle Assembly Disassembly and Reassembly

Manual Transaxle Assembly Disassembly and Reassembly

Manual Transaxle Unit Dismounting and Remounting

Manual Transaxle Assembly Components

Gear Shift and Select Shaft Assembly Removal and Installation

Disassembly

1) Remove back up lamp switch. Back Up Lamp Switch Removal and Installation
2) Remove transaxle case bolts.

3) Remove transaxle left side case (1) from right case using special tool.
Special Tool

(A): 09912-34510





4) Remove reverse gear shift lever bolts (1) and reverse gear shift lever (2).






5) Tapping input shaft end with plastic hammer, push it out as assembly from case a little, then take out input shaft assembly (1), countershaft assembly (2), high speed gear shift shaft (3), low speed gear shift shaft (4), 5th and 6th gear shift shaft (5), reverse gear shift (6) and reverse gears (7).





6) Remove differential assembly from right case.

Reassembly

Right Case Disassembly and Reassembly

Left Case Disassembly and Reassembly

Input Shaft Disassembly and Reassembly

Countershaft Disassembly and Reassembly

Differential Disassembly and Reassembly

Gear Shift Shaft and Fork Inspection
1) Install differential assembly into right case.
2) Join input shaft assembly (5), countershaft assembly (4), low speed gear shift shaft (2), high speed gear shift shaft (3), 5th and 6th gear shift shaft (6), reverse gear shift shaft (7) and reverse gears (8) assemblies all together, then install them into right case (1) so as not to damage oil seal by input shaft spline.

NOTE:
- Input shaft right bearing on shaft can be installed into right case (1) by tapping shaft with plastic hammer.
- Make sure that countershaft is engaged with final gear while installing.





3) Select input shaft shim and reverse gear washer as follows.
a) Measure depth "a" of left case (1) and "b" of right case (2) and measure depth "e" of left case and "f" of right case.
b) Measure distance "c" of input shaft assembly (3) and measure distance "g" of reverse gear assembly (4).
c) Calculate the clearance of "d" and "h" by the following expressions.














d) Select shims closest to clearance "d" and select washer closest to clearance "h" from among the following available sizes.

Available shim thickness










Available washer thickness






4) Install reverse gear lever (1) and then tighten new reverse gear lever bolts (2) to specified torque.

Tightening torque
Reverse gear shift lever bolt (a): 23 Nm (2.3 kgf-m, 17.0 lbf-ft)





5) Clean mating surfaces of both right and left cases, apply sealant to right case (1) as shown in the figure by such amount that its section is 1.5 mm (0.059 in.) in diameter then mate it with left case (2).

"A" Sealant: 99000-31260 (SUZUKI Bond No.1217G)

6) Tighten case bolts (3) to specified torque.

Tightening torque
Transaxle case bolt (a): 23 Nm (2.3 kgf-m, 17.0 lbf-ft)





7) Install back up lamp switch. Back Up Lamp Switch Removal and Installation