Operation CHARM: Car repair manuals for everyone.

ABS




DTC C1033: Wheel Speed Sensor Deviation

Wiring Diagram

Refer to "Wiring Diagram" under ABS DTC C1021 / C1022 / C1025 / C1026 / C1031 / C1032 / C1035 / C1036: Wheel Speed Sensor Circuit Failure / Range / Performance.

DTC Detecting Condition and Trouble Area






DTC Troubleshooting

1.
Was "ABS Check" performed?
YES -
Go to Step 2.
NO -
Go to ABS Check ABS Check.

2. Check tire condition

Check that tire pressure is specifications.

Are they in good condition?
YES -
Go to Step 3.
NO -
Replace tire or adjust tire pressure and recheck.

3. Check DTC for ABS

Connect SUZUKI scan tool to DLC with ignition switch turned OFF.
Turn ignition switch ON and check DTC for ABS.

Is DTC C1021, C1022, C1025, C1026, C1031, C1032, C1035 and/or C1036 detected together?
YES -
Go to ABS DTC C1021 / C1022 / C1025 / C1026 / C1031 / C1032 / C1035 / C1036: Wheel Speed Sensor Circuit Failure / Range / Performance
and recheck.
NO -
Go to Step 4.

4. Wheel speed sensor circuit check

Disconnect ABS hydraulic unit / control module connector and all wheel speed sensor connectors with ignition switch turned OFF.
Check for proper connection to ABS hydraulic unit / control module connector and terminals of wheel speed sensor.
If OK then check all wheel speed sensors circuit for open, short and high resistance.

Are wheel speed sensor circuits in good condition?
YES -
Go to Step 5.
NO -
Repair circuit and recheck.

5. Wheel speed sensor check

Inspection all wheel speed sensors referring to Front and Rear Wheel Speed Sensor Inspection Front and Rear Wheel Speed Sensor Inspection.

Are they in good condition?
YES -
Go to Step 6.
NO -
Clean or replace.

6. Wheel speed sensor encoder check

Inspection all wheel speed sensor encoders referring to Front Wheel Speed Sensor Encoder On-Vehicle Inspection Front Wheel Speed Sensor Encoder On-Vehicle Inspection
and Rear Wheel Speed Sensor Encoder On-Vehicle Inspection Rear Wheel Speed Sensor Encoder On-Vehicle Inspection.

Are they in good condition?
YES -
Go to Step 7.
NO -
Clean or replace wheel hub assembly.

7. Wheel speed sensor signal check

Inspection all wheel speed sensors referring to Front and Rear Wheel Speed Sensor On-Vehicle Inspection Front and Rear Wheel Speed Sensor On-Vehicle Inspection.

Are they in good condition?
YES -
Substitute a known-good wheel hub assembly and recheck. If DTC detected, substitute a known-good ABS hydraulic unit / control module and recheck.
NO -
Replace wheel speed sensor and recheck.