Gear Shift and Select Shaft Assembly Disassembly and Reassembly

Gear Shift and Select Shaft Assembly Disassembly and Reassembly

Manual Transaxle Unit Dismounting and Remounting

Gear Shift and Select Shaft Assembly Removal and Installation

Gear Shift and Select Shaft Assembly Components

Disassemble and reassemble gear shift and select shaft assembly while referring to the following precautions and figure.

- Push spring pins out using special tool below.
Special Tool

(A): 09925-78210
6.0 mm

- Inspect component parts for wear, distortion or damage. If any detect is found, replace detective part with new one.

NOTE:
The gear shift and select shaft may be bent if the spring pins are driven without using any support on the back of the spring pin fitting location.

Be sure to support the spring pin fitting location from behind with a wooden block when installing the spring pins.