P0461

DTC P0461

DTC Detecting Condition and Trouble Area






Wiring Diagram










DTC Confirmation Procedure

WARNING:

If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.

- Select a level road with no traffic to minimize the risk of accident.
- Perform the test extremely carefully.
- Perform the road test using 2 persons, a driver and an assistant.

NOTE:

If DTCs other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.

1) Warm up engine to normal operating temperature.
2) Drive vehicle at 50 - 100 km/h (31 - 62 mile/h) for 1 hour.

DTC Troubleshooting

1.
Was "Engine and Emission Control System Check" performed?
YES -
Go to Step 2.
NO -
Go to Engine and Emission Control System Check Engine and Emission Control System Check.

2. DTC check

Check DTC.

Is there any CAN-DTC?
YES -
Go to Precaution of Troubleshooting for CAN Precaution of Troubleshooting for CAN.
NO -
Go to Step 3.

3. Fuel level sensor power supply circuit check

Turn OFF ignition switch and disconnect connectors from combination meter and fuel level sensor.
Check for proper terminal connection to combination meter connector and fuel level sensor connector.
If connections are OK, check that fuel level sensor power supply circuit (A1) is as follows.
- Wiring harness resistance of fuel level sensor power supply circuit is less than 3 ohms.
- Insulation resistance between fuel level sensor power supply circuit and vehicle body ground is infinity.
- Insulation resistance of wire harness is infinity between fuel level sensor power supply circuit and each terminal at fuel level sensor connector.
- Circuit voltage of fuel level sensor power supply circuit is 0 - 1 V with ignition switch in ON position.

Are they in good condition?
YES -
Go to Step 4.
NO -
Repair or replace defective wire harness.

4. Fuel level sensor ground circuit check

Check that fuel level sensor ground circuit (A2) is as follows.
- Wiring harness resistance of fuel level sensor ground circuit is less than 3 ohms.
- Circuit voltage of fuel level sensor ground circuit and body ground is 0 - 1 V with ignition switch in ON position.

Are they in good condition?
YES -
Go to Step 5.
NO -
Repair or replace defective wire harness.

5. Fuel level sensor check

Check fuel level sensor. Fuel Level Sensor Inspection

Is it in good condition?
YES -
Go to Step 6.
NO -
Repair or replace defective parts.

6. DTC recheck

Replace combination meter. Service and Repair
Perform DTC confirmation procedure and check DTC.

Is DTC P0461 still detected?
YES -
Substitute a known-good ECM and recheck.
NO -
End.