P2764

DTC P2764

DTC Detecting Condition and Trouble Area






Wiring Diagram

Refer to P0741 DTC P0741.

DTC Confirmation Procedure

NOTE:

Check that the following conditions are satisfied when using this procedure.

- Battery voltage > 10.5 V

1) Turn ignition switch to ON position for 10 sec.

DTC Troubleshooting

1.
Was "CVT System Check" performed?
YES -
Go to Step 2.
NO -
Go to CVT System Check CVT System Check.

2. TCC solenoid valve drive circuit check

Turn off ignition switch and disconnect TCM and solenoid connectors.
Check for proper terminal connection to TCM and solenoid connectors.
If connections are OK, check that TCC solenoid valve drive circuit (A2) is as follows.
- Insulation resistance of wire harness is infinity between TCC solenoid valve drive circuit terminal and each terminal at solenoid connector.
- Circuit voltage of TCC solenoid valve drive circuit 0 - 1 V with ignition switch ON position.

Are they in good condition?
YES -
Go to Step 3.
NO -
Repair or replace defective wire harness.

3. TCC solenoid valve check

Check resistance of TCC solenoid valve. Testing and Inspection

Is it in good condition?
YES -
Substitute a known-good TCM and recheck.
NO -
Replace TCC solenoid valve (valve body assembly).