Removal and Installation

Sunload Sensor Removal and Installation

Removal

1) Disconnect negative (-) cable at battery.
2) Remove combination meter from instrument panel referring to Service and Repair Combination Meter Removal and Installation.
3) Remove sunload sensor (1) from instrument panel by depressing tab and pushing sensor upward from underneath.
4) Disconnect sunload sensor connector (2).






Installation

Sunload Sensor Inspection:Auto A/C

Reverse removal procedure noting the following instructions.

- Install sunload sensor (1) to instrument panel fitting tab (2) of sunload sensor into the groove (3) of instrument panel as shown in figure.