Procedure K - Axle Shaft/Hub Runout Inspection

Hub Face Runout:

1. Measure hub face runout with dial indicator. If runout exceeds specification, replace hub.

Specification: 0.1 mm (0.004 in.)

2. Remove axle shaft from housing. Utilizing V-blocks or machine centers, measure axle shaft runout. If runout exceeds specification, replace axle.

Specification: 1.5 mm (0.059 in.)
PART APPLICATION

Special weighted bolts from Procedure 1, Method 1, Step 6, are applicable to all models with standard rear-wheel-drive driveshafts.

PART NUMBER INFORMATION

New Part Number Part Name

90101-08085 Bolt, Driveshaft, Weighted, 2 gram
90101-08086 Bolt, Driveshaft, Weighted, 4 gram
90101-08087 Bolt, Driveshaft, Weighted, 6 gram
90170-08007 Nut (standard part)
94512-00800 Washer, Lock (standard part)