V.Igniter Replacement Procedure and Completion Label

Removal of Igniter:

Removal of Igniter

1. Remove rotor, ignition coil cover and igniter cover.


2. Disconnect the red and brown wires from the (+) ignition coil terminal.


3. Disconnect the yellow and blue wires from the (-) ignition coil terminal.


4. Disconnect the pink and white wires from the igniter unit.

Removal of Igniter:

5. Remove the two igniter retaining screws and lift the igniter out of the distributor housing.


6. Discard the retaining screws.

Removal of Igniter:

7. Disconnect the black wire from the igniter.


8. Discard the igniter.

Replacement of Igniter:

Replacement of Igniter


1. Attach black wire to the igniter.


2. Install new igniter using two new retaining screws.
3. Install the pick-up coil (signal generator) lead wire as indicated below.

NOTE: There are two types of terminals on pick-up coil lead wires.

4. Insert pink and white wires into clamp as illustrated.

Separate Nut Terminal:

Separate Nut Terminal


Twist lead wires as illustrated, then install white wire terminal first onto the pick-up coil side igniter terminal.

Welded Nut Terminal:

Welded Nut Terminal


Install white wire terminal first onto the pick-up coil side igniter terminal without twisting the lead wires.

Wire Routing:

5. Check that the wires do not contact the rotor, distributor housing or advance plate.


6. Route red and yellow wires from the igniter so that it will not contact any moving parts.

Wire Routing:

7. Connect brown wire, then red wire to the (+) ignition coil terminal.


8. Connect yellow wire, then blue wire to the (-) ignition coil terminal.


9. Check that wires are routed properly into the grooves as illustrated.

Igniter:

10. Install igniter cover, coil cover, rotor and distributor cap.


11. Connect green wire connector to the distributor assembly.

CLAMPS:

12. Close the No. 2 engine cover and fold the center floor carpet down.

Note: Hand tighten the set bolts first starting at the console assembly; then tighten.


13. Install the two clamps as illustrated, then attach the accelerator cable.


Note: Install clamp B first.

FRONT PASSENGER SEAT ASSEMBLY:

14. Connect parking brake switch wire, for A/T connect indicator lamp wire and transmission relay.


15. Install console box assembly.


M/T: Install the shift lever knob.


16. Close the No. 1 engine cover and fold carpet down.


17. Install inner seat belt and torque to 32 ft.lbs.


18. Install front passenger seat assembly and torque to 27 ft.lbs.

COMPLETION LABEL:

VI. COMPLETION LABEL

Following the installation of the igniter, a SSC completion label must be affixed to the left front door post near the door hinge.
Additional SSC completion labels (00410-01917) may be ordered through the non-parts system on a 1450 order form or through the TDN system.