Reading and Clearing Diagnostic Trouble Codes
Type A1. Turn the ignition switch on.
2. Push the SET/COAST switch on, and keep it on.
3. Push the main switch on.
4. Check that the indicator light "CRUISE" lights-on in the combination meter and after 3 seconds check that the indicator light "CRUISE" blinks.
5. Turn the SET/COAST switch off.
6. Meet the conditions listed below.
7. Read the diagnostic trouble code on the indicator light "CRUISE".
HINT:
- Indication codes appear in order from No.1.
- If there is no indication code, refer to Diagnosis by Symptom.
Code Inspections
- Indication is stopped, when the MAIN switch is repushed.
Type B
1. If the system is canceled by a malfunction in either the actuator, speed sensor or cruise control switch circuit while driving with the cruise control on the cruise control indicator light "CRUISE" will blink 5 times.
2. While stopping, connect terminals 3 and 11 of the Data Link Connector 1.
HINT: If the ignition switch is turned off, the diagnostic trouble code will be erased from the ECU memory.
3. Read the diagnostic trouble code on the indicator light "CRUISE".
HINT:
- Indication codes appear in order from No.1.
- If there is no indication code, refer to Diagnosis by Symptom.
Code Inspections