Flywheel M/T

INSTALL DRIVE PLATE





Clean the mount bolt threads and crankshaft bolt holes of any residual sealer, oil or foreign particles.
Remove any oil with kerosene or gasoline.
Apply adhesive to two or three threads of the mount bolt end.

Adhesive: Part No.08833-00070, THREE BOND 1324 or equivalent.
This sealant will not harden while exposed to air.
It will act as a sealer or binding agent only when applied to threads, etc. when the air is cut off.

Install the drive plate on the crankshaft.
Install and uniformly tighten the bolts in several passes, in the sequence shown.

Torque: 87 Nm (890 kgf-cm, 64 ft.lbs.)