Displaying & Reading Trouble Codes

DIAGNOSTIC TROUBLE CODES OUTPUT
To obtain an output of diagnostic trouble codes, proceed as follows:
1. Turn the ignition switch ON.

NOTICE: Do not start the engine.





2. Using SST, connect terminals TE1 and E1 of the DLC1.
SST 09843-18020

HINT: The DLC1 is located under the driver's seat.





3. Read the diagnostic trouble code as indicated by the number of flashes of the "OIL LEVEL" warning light.





(a) Normal System Operation (no malfunction)
^ The light will blink once every 4.5 seconds.





(b) Malfunction Code Indication
^ The light will blink a number of times equal to the malfunction code indication as follows:
1. Between code and code 2.5 seconds.
2. Between all malfunction codes 4.5 seconds. The diagnostic trouble code series will be repeated as long as the DLC1 terminals TE1 and E1 are connected.

HINT: In the event of a number of trouble codes. indication will begin from the small value and continue to the larger in order.

4. After the diagnosis check, remove the SST from the DLC1.
SST 09843-18020