Installation

1. Install a new gasket.






2. Install the differential carrier assembly in the axle and install the 10 nuts. Torque to 73 Nm (54 ft.lbs).






3. Remove the pinion shaft pin from the differential.






4. Remove the pinion shaft and spacer.

Note: When the pinion shaft is removed, the pinion gear and thrust washer will come off also.

5. Connect the rear propeller shaft and the rear axle shafts.
6. Install a new gasket and the rear differential cover.






7. Fill the differential with gear oil.

^ Oil type: Hypoid gear oil API GL-5
^ Viscosity: Above -18°C (0°F) SAE 90
Below -18°C (0°F) SAE 80W or 80W-90
^ Capacity: 2.8 liters (2.9 US qts.)

8. Install drain plug.