Preparation For Disassembly

1. M/T: Remove flywheel.
Remove the 10 bolts and flywheel.
A/T: Remove drive plate.
Remove the 10 bolts, front spacer, drive plate and rear plate.
2. Remove rear end plate.
Remove the 3 bolts and rear end plate.
3. Install engine to engine stand for disassembly.
4. Remove cylinder head.
5. Remove timing chains, gears and sprocket.
6. Remove fuel filter.





7. Remove knock sensor.
Using Special Service Tool (SST) Oil Pressure Switch Socket # 09816 - 30010 or equivalent, remove the knock sensor.
8. Remove water bypass pipe.
Remove the bolt and water bypass pipe.
9. Remove oil filter.
10. Remove oil filter bracket.
(a) Remove the nut, union bolt, gasket and oil filter bracket.
(b) Remove the O-ring from the union bolt.
11. Remove engine coolant drain plug.





12. Remove oil pressure switch.
Using SST Oil Pressure Switch Socket # 09816 - 30010 or equivalent, remove the oil pressure switch.
13. Remove RH and LH engine mounting assemblies.
Remove the 4 bolts and mounting assembly.
14. Remove engine wire bracket.
15. Remove crankshaft position sensor connector bracket.