Crankshaft Position Sensor: Service and Repair

INSTALLATION HINT: Installation is in the reverse order of removal.

1. REMOVE ENGINE UNDER COVER.
2. REMOVE ALTERNATOR.
3. REMOVE ALTERNATOR BRACKET.





- Remove the 3 bolts and bracket.

- Torque:
Bolt A: 74.5 Nm (55 ft lb)
Bolt B: 18 Nm (13 ft lb)

4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR.
5. REMOVE CRANKSHAFT POSITION SENSOR.





- Remove the 2 bolts and crankshaft position sensor.

- Torque: 8.5 Nm (74 in lb)

- Remove the O-ring.

INSTALLATION HINT:

- Always use a new O-ring when installing the crankshaft position sensor.
- Apply a light coat of engine oil on the O-ring.