Coolant Temperature Sensor/Switch (For Computer): Service and Repair

NOTICE: Installation is in the reverse order of removal.

1. DRAIN ENGINE COOLANT.
2. DISCONNECT UPPER RADIATOR HOSE FROM WATER OUTLET.
3. REMOVE NO.2 TIMING BELT COVER.
- Disconnect the PS air hose from the clamp.
- Disconnect the 3 cord clamps of the high-tension cords from the belt cover.





- Remove the 6 bolts. timing belt cover and gasket.
- Disconnect the camshaft position sensor connector.
4. REMOVE FUEL PIPE.
5. REMOVE ECT SENSOR.
- Disconnect the ECT sensor connector.





- Using a 19 mm deep socket wrench, remove the ECT sensor and gasket.

HINT: Use a new gasket upon reassembly.