Normal Mode

NOTICE: When the diagnosis system is switched from normal mode to check mode, it erases all diagnostic trouble codes and freeze frame data recorded in normal mode. So before switching modes, always check the diagnostic trouble codes and freeze frame data, and note them down.

1. Prepare the TOYOTA hand-held tester.





2. Connect the TOYOTA hand-held tester to DLC3 at the lower of the instrument panel.
3. Turn the ignition switch ON and turn the TOYOTA hand-held tester switch ON.
4. Use the TOYOTA hand-held tester to check the diagnostic trouble codes and freeze frame data, note them down.
(For operating instructions, see the TOYOTA hand-held tester's instruction book.)
5. See Diagnostic Charts to confirm the details of the diagnostic trouble codes.