Crankshaft Position Sensor: Service and Repair

1. REMOVE ENGINE UNDER COVER
2. REMOVE ALTERNATOR
3. REMOVE ALTERNATOR BRACKET





- Remove the 3 bolts and bracket.

Torque:
Bolt A: 74.5 N.m (760 kgf.cm, 55 ft.lbf)
Bolt B: 18 N.m (180 kgf.cm, 13 ft.lbf)





4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR
5. REMOVE CRANKSHAFT POSITION SENSOR
- Remove the 2 bolts and crankshaft position sensor.

Torque: 8.5 N.m (85 kgf.cm, 74 in.lbf)

- Remove the O-ring.

INSTALLATION HINT:
- Always use a new O-ring when installing the crankshaft position sensor.
- Apply a light coat of engine oil on the O-ring.

INSTALLATION

INSTALLATION HINT:Installation is in the reverse order of removal.