Crankshaft Position Sensor: Service and Repair

REMOVAL

1. Disconnect negative (-) terminal cable from battery.

CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.

2. Disconnect crankshaft position sensor connector.
3. Remove crankshaft position sensor.





Remove the 2 bolts and crankshaft position sensor.

INSTALLATION

1. Install crankshaft position sensor.
- Apply a light coat of engine oil on the 0-ring.
- Install the crankshaft position sensor with the 2 bolts.

Torque: 8.5 Nm (74 in lb)

2. Connect crankshaft position sensor connector.
3. Connect negative (-) terminal cable to battery.