Crankshaft Position Sensor: Service and Repair

REMOVAL
1. REMOVE ENGINE UNDER COVER.
2. REMOVE GENERATOR.





3. REMOVE GENERATOR BRACKET.
- Remove the 3 bolts and bracket.

Torque:
Bolt A: 74.5 Nm (55 ft lb)
Bolt B: 18 Nm (13 ft lb)

4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR.





5. REMOVE CRANKSHAFT POSITION SENSOR.
- Remove the 2 bolts and crankshaft position sensor.

Torque: 8.5 Nm (74 in lb)

- Remove the O-ring.

CRANK SHAFT POSITION SENSOR INSTALLATION

INSTALLATION HINT: Installation is in the reverse order of removal.