Disassembly and Assembly

NOTE: For removal and installation procedures refer to "Manual Transmission/Transaxle, Service and Repair."





OIL SEAL REPLACEMENT
1. If necessary, replace front bearing retainer oil seal, as follows:





a. Using a screwdriver, pry out the oil seal.





b. Using Special Service Tool (SST) 09950-60010 (09951-00510), 09950-7001 0 (09951- 07150) or equivalents, and a hammer, drive in a new oil seal.
Drive in depth: 11.7 +/- 0.5 mm (0.461 +/- 0.020 inch) from retainer end.