Rear

Rear Speed Sensor Components:

REMOVAL
1. Remove speed sensor.
(a) Disconnect the speed sensor connector, and pull out the sensor wire harness with grommet.
(b) Remove the 5 resin clips, holding the sensor wire harness from the frame, upper control arm and axle housing.

Disconnect Speed Sensor Connector:

(c) Remove the mounting bolt and speed sensor.
Torque: 8.0 Nm (71 inch lbs.)

INSTALLATION
Installation is in the reverse order of removal.
After installation, check speed sensor signal.

CAUTION: Make sure that:
- There are no foreign objects on the sensor or the part of the knuckle to which the sensor is to be installed.
- The sensor is installed flat against the knuckle when you tighten the bolt.
- When installing the resin clips, use new ones.