Knock Sensor: Service and Repair

COMPONENTS FOR REMOVAL AND INSTALLATION

KNOCK SENSORS REMOVAL

1. DRAIN ENGINE COOLANT
2. REMOVE AIR CLEANER HOSE
3. REMOVE INTAKE AIR CONNECTOR
4. REMOVE HIGH-TENSION CORDS WITH IGNITION COILS
5. REMOVE TIMING BELT, CAMSHAFT TIMING PULLEYS AND NO.2 IDLER PULLEY
6. REMOVE FUEL PRESSURE REGULATOR
7. REMOVE INTAKE MANIFOLD ASSEMBLY
8. REMOVE WATER BYPASS PIPE WITH KNOCK SENSOR WIRE





9. REMOVE KNOCK SENSORS
Using SST, remove the knock sensor. SST 09816-30010

KNOCK SENSORS INSTALLATION

1. REINSTALL KNOCK SENSORS
Using SST, install the knock sensor. SST 09816-30010

Torque: 39 N.m (400 kgf.cm. 29 ft.lbf)

2. REINSTALL WATER BYPASS PIPE WITH KNOCK SENSOR WIRE
3. REINSTALL INTAKE MANIFOLD ASSEMBLY
4. REINSTALL FUEL PRESSURE REGULATOR
5. REINSTALL NO.2 IDLER PULLEY, CAMSHAFT TIMING PULLEYS AND TIMING BELT
6. REINSTALL HIGH-TENSION CORDS WITH IGNITION COILS
7. REINSTALL INTAKE AIR CONNECTOR
8. REINSTALL AIR CLEANER HOSE
9. REFILL WITH ENGINE COOLANT
10. RECHECK ENGINE COOLANT LEVEL