Transmission Temperature Sensor/Switch: Service and Repair

REPLACEMENT
1. Disconnect Automatic Transmission Fluid (ATF) Temperature sensor connector.
2. Remove ATF temperature sensor, as follows:





a. Remove the ATF temperature sensor.
b. Remove the O-ring from the ATF temperature sensor.
3. Install ATF temperature sensor, as follows:
a. Coat a new O-ring with ATF and install it to the ATF temperature sensor.
b. Install the ATF temperature sensor.
Torque: 15 N.m (11 ft. lbs.).
4. Connect ATF temperature sensor connector.

INSTALLATION NOTICE: Be careful not to twist the wire harness.