Inspection and Replacement

Non-Tilt Steering Column / With Automatic Transmission (1 Of 2):

Non-Tilt Steering Column / With Manual Transmission (1 Of 2):

Non-Tilt Steering Column (2 Of 2):

INSPECTION AND REPLACEMENT





1. Inspect column upper bracket. Check that steering lock mechanism operates properly.
2. If necessary, replace key cylinder, as follows:
a. Place the ignition key at the ACC position.





b. Push down the stop pin with a thin rod, and pull out the key cylinder. Install a new key cylinder.

NOTE: Make sure the ignition key is at the ACC position.

3. Inspect ignition switch and key unlock warning switch.
4. If necessary, replace ignition switch and key unlock warning switch, as follows:
a. Remove the three screws.
b. Install a new switches with the three screws.





5. Inspect bearing. Check bearing rotation condition and check for abnormal noise. If the bearing is worn or damaged, replace the column tube/column upper tube.
6. If necessary, replace bushing, as follows:





a. Using a screwdriver, remove the bushing from the column tube/column lower tube.

NOTICE: Be careful not to damage the column tube.

b. Coat the inside of new bushing with molybdenum disulfide lithium base grease.
c. Align the holes of the tube and the projections of the bushing, and install the bushing into the column tube/ column lower tube.