Oil Pan: Service and Repair

REMOVAL
1. Remove the 15 bolts and 4 nuts.





2. Using Special Service Tool (SST) Oil Pan Seal Cutter # 09032 - 00100 or equivalent and a brass bar, separate the oil pan from the cylinder block.

NOTE: When removing the oil pan, be careful not to damage the oil pan flange.

INSTALLATION





1. Apply seal packing to the oil pan, as shown in the illustration.
Seal packing: Part No. 08826 - 00080 or equivalent.
- Install a nozzle that has been cut to a 3 - 4 mm (0.12 - 0.16 inch) opening.

NOTE: Avoid applying an excess amount to the surface.

- If parts are not assembled within 5 minutes of applying the seal packing, the effectiveness of the seal packing is lost and the seal packing must be removed and reapplied.
- Immediately remove the nozzle from the tube and reinstall the cap after using the seal packing.
2. Install the oil pan with the 2 nuts and 17 bolts.
Torque: 7.6 Nm (67 inch lbs.)