Drive Belt: Service and Repair

REMOVAL
1. REMOVE PS PUMP DRIVE BELT
2. REMOVE ENGINE UNDER COVER

3. REMOVE DRIVE BELT
a. Loosen the idle pulley lock nut.
b. Loosen the drive belt tension by adjusting bolt and remove the drive belt.

INSTALLATION

1. TIGHTEN IDLE PULLEY LOCK NUT TEMPORALLY
Torque: 2.5 N.m (25 kgf.cm, 22 in.lbf)

2. INSTALL DRIVE BELT
3. USING ADJUSTING BOLT, ADJUST DRIVE BELT TENSION
Drive belt tension
New belt: 160 ± 25 lbf
Used belt: 100 ± 25 lbf

4. TIGHTEN IDLE PULLEY LOCK NUT
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)

5. INSTALL PS PUMP DRIVE BELT
6. INSTALL ENGINE UNDER COVER