Keyless Entry - Programming Remote Transmitters: Overview
ELECTRICALEL009-98
December 4, 1998
Title:
PROGRAMMING OEM WIRELESS DOOR LOCK REMOTE TRANSMITTERS
Models:
'98 - '99 Sienna
Introduction
This bulletin describes procedures used to program the three or four button remote transmitter to vehicles that are equipped with Wireless Door Lock Control. The following information applies only to the Factory Wireless Door Lock Control, not dealer or port installed options that also utilize remotes, such as VIP Keyless Entry/RS3000 or any aftermarket system.
Verification of Factory Wireless Door Lock Control can easily be performed by identifying the TDS status monitor, functioning remote, or model grade.
^ The Remote Transmitter has LOCK, UNLOCK, and PANIC features.
^ The TDS Status Monitor is located to the left of the steering column.
NOTE:
When a new remote is programmed, all previous codes are erased. Because of this, all remotes should be entered during the same programming session, otherwise a remote may no longer be registered and operate the vehicle.
Affected Vehicles
^ 1998-1999 Siennas:
All XLE (standard equipment)
Some LE (optional)
Warranty Information