Crankshaft Position Sensor: Service and Repair

REMOVAL

1. REMOVE ENGINE UNDER COVER
2. REMOVE GENERATOR





3. REMOVE GENERATOR BRACKET Remove the 3 bolts and bracket.

Torque:
Bolt A: 74.5 N.m (760 kgf.cm, 55 ft.lbf)
Bolt B: 18 N.m (180 kgf.cm, 13 ft.lbf)

4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR
5. REMOVE CRANKSHAFT POSITION SENSOR





(a) Remove the 2 bolts and crankshaft position sensor.

Torque: 8.5 N.m (85 kgf.cm, 74 in.lbf)

(b) Remove the O-ring.

HINT
- At the time assembly, please refer to the following items.
- Install the crankshaft position sensor with a new gasket.
- Always a new O-ring when installing the crankshaft position sensor.

INSTALLATION
Installation Is in the reverse order of removal.