Disassembly and Assembly

DISASSEMBLY
1. Remove oil seal (inside).
a. Clamp the axle hub in a soft jaw vise.

HINT: Close vise until it holds hub bolts. Do not tighten further.

b. Using a screwdriver, remove the oil seal (inside).

2. w/ Free wheel hub: Remove lock nut and ABS speed sensor rotor/spacer.
a. Using a hammer and a chisel, loosen the staked part of the lock nut.

NOTICE: Be careful not to damage the bushing.





b. Using SST 09318-12010, remove the lock nut.
c. Remove the ABS speed sensor rotor/spacer.

NOTICE: Take care not to scratch the serration of the speed sensor rotor.

3. Remove axle hub from steering knuckle.
a. Remove the 4 bolts and shift the brake dust cover towards the hub side (outside).





b. Using SST 09710-30021 (09710-03051), 09950-40010 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04030, 09957-04010, 09958-04010), remove the axle hub from the steering knuckle.

c. w/o Free wheel hub: Remove the bearing spacer and ABS speed sensor rotor/spacer.

4. Remove oil seal (Outside). Using a screwdriver, remove the oil seal (outside) from the steering knuckle.

5. Remove bearing from steering knuckle.
a. Using snap ring pliers, remove the snap ring.





b. Using SST 09950-60020 (09951-00810), 09950-70010 (09951-07150) and a press, remove the bearing from the steering knuckle.





ASSEMBLY
1. Install new bearing.
a. Using SST 09527-17011, 09950-60020 (09951-00910) and a press, install a new bearing to the steering knuckle.
b. Using snap ring pliers, install the snap ring.





2. Install new oil seal (Outside).
a. Using SST 09223-15030, 09527-17011 and a plastic hammer, install a new oil seal (outside).
b. Coat MP grease to the oil seal lip.

3. Install axle hub to steering knuckle.
a. Install the brake dust cover to the steering knuckle with the 4 bolts.

Torque to 18 Nm (13 ft. lbs.)





b. Using SST 09649-17010 and a press, install the axle hub to the steering knuckle.

4. Install ABS speed sensor rotor/spacer.

NOTICE: Do not scratch the serration of the speed sensor rotor.





5. w/ Free wheel hub: Install new lock nut.
a. Using SST 09318 - 12010, install and torque a new nut to the axle hub.

Torque to 274 Nm (203 ft. lbs.)

b. Using a chisel and hammer, stake the nut.





6. w/o Free wheel hub: Install bearing spacer.
a. Using SST 09950-60010 (09951-00650), 09950-70010 (09951-07150) and a press, install the bearing spacer.





7. Install new oil seal (Inside).
a. Using SST 09527-17011 and a plastic hammer, install a new oil seal (inside).

HINT: Strike the SST on its circumference evenly.

b. Coat MP grease to the oil seal lip.