Oil Seal

OIL SEAL





Components

Replacement





1. IF NECESSARY, REPLACE FRONT BEARING RETAINER OIL SEAL
a. Using a screwdriver and hammer, drive out the oil seal.
b. Using SST and a hammer, drive in a new oil seal until its surface is flush with the retainer upper surface.
SST 09950 - 60010 (09951 - 00590), 09950 - 70010(09951 - 07100)
c. Coat the lip of the oil seal with MP grease.
2. IF NECESSARY, REPLACE FRONT CASE OIL SEAL
a. Using a screwdriver and hammer, drive out the oil seal.





b. Using SST and a hammer, drive in a new oil seal until its surface is flush with the case upper surface.
SST 09316 - 60011 (09316 - 00011)
c. Coat the lip of the oil seal with MP grease.
3. IF NECESSARY, REPLACE EXTENSION HOUSING OIL SEAL
a. Using a screwdriver and hammer, drive out the oil seal.





b. Using SST and a hammer, drive in a new oil seal until its surface is flush with the housing upper surface.
SST 09554 - 22010
c. Coat the lip of the oil seal with MP grease.
4. IF NECESSARY, REPLACE FRONT AND REAR COMPANION FLANGE OIL SEALS
a. Using a screwdriver and hammer, drive out the oil seals from the 2 flanges.





b. Using SST and a hammer, drive in a new oil seal.
SST 09950 - 60010 (09951 - 00220, 09951 - 00350, 09952 - 06010), 09950 - 70010 (09951 - 07100)
c. Coat the lip of the oil seal with MP grease.





5. IF NECESSARY, REPLACE SHIFT FORK SHAFT OIL SEALS
a. Using a screwdriver, pry out the oil seal.
b. Using SST and a hammer, drive in a new oil seal.
SST 09304 - 12012

Oil seal depth: -0.5 - 0.5 mm (-0.020 - 0.020 inch)





6. w/ One touch 2-4 selector system: Only when replacing the front case
IF NECESSARY, REPLACE PLUG
Using a hexagon wrench (19 mm) and hammer, drive in a new plug.